When installing a long travel suspension system and/or crossover steering the front drive shaft spline is just not long enough to get the job done. The kit allows a full 8″ of slip travel. This is a very high quality drive line kit that is Made in Japan! Spline profile is same as stock, just longer! We have used these to replace worn out splines as well. Can be used front or rear, uses standard 10mm driveshaft found on all 1984-1995 4wd trucks and 4runners.
Includes a new high quality Japanese-made Matsuba U-Joint, which is the same u-joint as stock 1984-1995 Pickup & 4Runner applications.
To install, cut the tube from your drive shaft and replace with a length of .095 or .120 wall tubing. Set up the drive shaft so that you have 3″ of compression and 5″ of extension at ride height.