Description

Power Flow Steering Pump Rebuild Kit

Power steering pumps in racing, rock crawling and off-road applications undergo way more stress than those used under normal conditions.  However long it takes, eventually your Power Flow pump may be out of warranty and need to be rebuilt.  More often than not, a properly rebuilt steering pump will be as good as new after replacing the wear components.  Trail-Gear’s Power Flow Steering Pump Rebuild Kit contains all of the internal wear components needed to rebuild any of our Power Flow PS steering pumps and get you back on the trail.  With Trail-Gear’s step by step instructions, rebuilding the pump is simple.

Kit Contents:

  • Pressure plate
  • Thrust Plate
  • Rotor
  • Vanes
  • Ring
  • Alignment pins

 

IMPORTANT: This rebuild kit contains replacements for the wear components in our Power Flow PS Steering pumps.  It is intended as a lower-cost alternative to outright replacement of your steering pump and is for use with older, aging Power Flow Steering Pumps that are no longer under warranty.  Replacement of the wear components will not necessarily resolve all potential damage or issues in your steering pump.  As such, Trail-Gear cannot guarantee the results associated with the use of this product.

If your Power Flow Steering Pump is still under warranty, click the “Policies” link above and follow the instructions for warranty claim.

NOTE: This item is intended for use with our Trail-Gear Power Flow PS Pumps only.  To verify that your pump is a genuine Power Flow PS Steering Pump, look for these markings:

Power Flow PS Pump markings

The following products can be rebuilt with this kit:

  • 130304-1-KIT – PS Pump w/ Pulley (1650psi)
  • 130303-KIT – PS Pump w/o Pulley (1650 psi)
  • 130329-1-KIT – PS Pump w/ Serpentine Pulley (1450psi)
  • 300154-1-KIT – PS Pump w/ Serpentine Pulley (1650psi)

Specifications:

  • All hardened components
  • Designed for performance and durability
  • Designed to fit TG Power Flow pump

Application Data:

  • Universal